Have a question? Give us a call: 0086-15355876682

Precautions when locking and tagging out safety locks

Things to note before locking and tagging are as follows:

1. First check whether the safety padlock itself is intact and can be used normally. The check mark must be filled in, and whether all types of content are filled in in detail and accurately. It can be locked only if there are no problems.

2. When locking and tagging, the tag must be hung on the lock, and then the main power switch of the electrical engineering of the equipment must be turned off.

3. After locking and tagging, all employees in the work area should be notified through various channels. The device is locked. Without permission and the presence of relevant personnel, no one can cancel the locking process of the device at will. Only the person who locked the device or authorized personnel is qualified to unlock the device.

4. During construction, installation, overhaul, infrastructure, maintenance, inspection, and operation, if the stored items are classified as dangerous goods, or the energy is easily released suddenly and cause damage, protect all potentially dangerous energy and remove it before doing so and lock out and tag out.

 safety padlock

5. Before locking out and tagging out, all operators, affected equipment and system software affected by this protection should be notified, and related operations should be terminated.

6. Employees who perform locking and tagging operations must pay attention to relevant equipment and system software, clear and disconnect all remaining kinetic energy, and ensure that equipment and routes are in a zero kinetic energy state.

7. After the repair or maintenance work is completed, before declaring the equipment and system to be repaired, the relevant personnel and total number of people should be fully checked to ensure that the relevant personnel present have evacuated the site and left the equipment and system.

8. Every time a safety padlock is tagged and locked, all relevant records must be properly kept to ensure that the locking and tagging are carried out in accordance with the corresponding technical specifications.


Post time: Dec-11-2023

Send your message to us:

Write your message here and send it to us

Get the data sheet or free quote

Write your message here and send it to us